Idex Fast & Fluid Management Giotto Compact Consignes D'installation Et D'utilisation page 13

Fast & Fluid Management Srl
A Unit of IDEX Corporation
3.- ASSEMBLY
Identify the right side (2) and the left one (3).
Put the superior plate (1) in the corret assembly position.
Assemble using screws type "C".
Assemble on the sides (2) and (3) the back panel (4) using screws type "B".
Assemble the guide (5) and (6) with the angulars (7) on the side (2) using screws type "D".
Lower the turning table (6) onto the motor shaft pre-assembled on the support plane (1) and
block it using washer and screw (DIAGRAM 2).
Assemble on the turning table (6) complete canisters (8), inserting them in their place . Block
each canister on the turning table (6), from below, using the screws supplied and keeping free
hole (7). (DETAIL 1) - (DIAGRAM 2)
_______________________________________________________________________________________________
DIAGRAM 1
1155007C-it,en,fr.doc – 16/10/2003
13