Check Content Of Delivery; Assembling The Armchair; Using The Armchair; Set The Lying Position - Duo Collection WATSON XXL Mode D'emploi

Check content of delivery

NOTE!
Damage risk!
If you open the packing without due care
with a sharp knife or other pointed tool.
Then the armchair could easily be
damaged.
Therefore please take great care
when opening.
1. Remove the armchair from the packaging.
2. Check for any visible signs of damage. If there are any,
please do not use the armchair. Contact your retailer.
3. Check that the contents of the delivery are complete.

Assembling the armchair

WARNING!
Risk of injury!
Improper use of the armchair can result
in serious injury.
To avoid any injuries caused by
pinching, take care when moving.
1. Place the seat 4 of the armchair on a flat surface.
2. Take the rest 1 and lift it over the seat.
3. Place the guide rail 6 of the rest carefully on the guide
pin 2 on the seat.
4. Press down firmly from above, until the back rest clicks
into place and cannot be moved.
5. The cover 5 comes with a hook and loop fastening.
Attach the cover so that it fits tightly over the seat.
6. Put the plug into the mains socket.

Using the armchair

WARNING!
Risk of injury!
Improper use of the armchair can result in
serious injury.
If the event of any fault with the electrics,
please contact a specialist. Damaged
electrical devices should not be used.

Set the lying position

In this mode, you can adjust the back rest and the foot rest on
the armchair. This means you can reach a lying position.
1. Sit in the armchair.
2. Press the button for lying position 9 on your remote control 7.
The back rest moves back. The foot rest moves up.
3. If you do not want a full lying position, you can select an
intermediate position. To do this, press the lying position button
until you have reached the position you want.
4. If you release the button, the back rest and foot rest stop
moving.
5. If you would like to go back to the upright position, press the
button for standing assistance 8.

Set the standing assistance

This mode helps you when standing up from the armchair. This
makes the chair go up slightly and tip forwards a little.
1. Sit in the armchair.
2. Press the button for standing assistance 8 on your remote
control. The armchair straightens up.
3. Stand up.

Faults

WARNING!
Risk of injury
The armchair contains a motor. Be careful.
If you discover any faults, remove the
mains plug.
If it stops working, check the connection
of the plug to the mains.

Cleaning

NOTE!
Risk of damage!
Improper use of cleaning utensils may
result in damage.
Do not use any solvents or other
aggressive or abrasive cleaning
materials. These could damage the
surface.
Do not use any abrasive sponges,
brushes or similar for cleaning.
Do not use any sharp cleaning
implements such as knives or hard
scrapers for cleaning.
Remove any dirt with a soft, lightly moistened cloth and if
required a little mild detergent.

Storage

Clean the armchair.
Take the armchair apart in reverse order to that described
in the chapter "Assembly".
For storage, we recommend use of the transport
packaging supplied.
Choose a storage area which is dry and well ventilated.

Transport

NOTE!
Risk of damage!
Improper use of the armchair may cause
damage to it.
If you want to move the armchair, then
push it from behind. Do not pull the
covers. They might tear.
Do not move the armchair while someone
is sitting in it.

Disposal

Disposal of packaging
Dispose of packaging appropriately. Put the
cardboard and cartons into paper recycling,
plastic sheet into other recycling.
Disposal of the armchair
Dispose of the armchair in accordance with the relevant
regulations for disposal in your country.
Manufacture
DUO Collection Import
Vertriebsgesellschaft mbH
Kaethe-Kruse-Straße 5
26160 Bad Zwischenahn