Remote Controller - Onkyo NS-6130 Mode D'emploi

> Before Start > Part Names

Remote Controller











> Install > Initial Setup




> Playback
1. Í button: Turns the unit on or into standby mode.
2. DIMMER button: Switch the display off or adjust the brightness of the display in two steps.
3. INPUT SELECTOR buttons: Switches the input to be played.
4. Play buttons:
: Move to the track before the one being played.
:
/;: Play or pause play.
9: Move to the next track.
∫: Stop playback.
0 Depending on the input, the operation may not start.
5. REPEAT button: Set repeat play.
SHUFFLE button: Set shuffle play.
6. CLEAR button: Used when entering text, etc
7. TOP MENU button: Move to the top menu of the selected input.
8. Cursors, ENTER button: Select the item with the cursors and press ENTER to confirm.
9. SETUP button: Displays the setup menu.
10.Amplifier control buttons
Use to switch the input, adjust the volume, etc., of an Onkyo pre-main amplifier.
0 Operation may not be possible with some amplifiers.
11. Í AMP button: Switch an Onkyo pre-main amplifier between on and standby.
0 Operation may not be possible with some amplifiers.
12.DISPLAY button: Switches the information on the display.
13.NOW PLAYING button: When you have changed the display during play, for example, this
button returns the display to show information about the file being played.
14. button: Returns the display to the previous state.
0 22 and 11 are not used.
Advanced Setup | Firmware Update | Others
Approx. 5 m
E
N
5