English - FIBARO SWIPE FGGC-001 Mode D'emploi

Read the full manual
attempting to install the device!
For full instruction manual and
technical specification please visit
our website:
manuals.fibaro.com/en/swipe
FIBARO Swipe (FGGC-001) is a revolutionary,
battery-powered gesture control pad that allows you
to control devices through the Z-Wave network. Swipe
your hand up, down, left or right in front of the pad,
make circular gestures and use sequences of gestures
to get full and intuitive control of your smart home.
Activation
1) Remove the front magnetic cover.
2) Dismount the Swipe from the back case by sliding
the device down.
3) Remove the paper stripe protecting the batteries.
4) Mount the Swipe back into the back casing
by sliding the device up.
5) The device will confirm powering up with an
acoustic signal.
Adding
1) Place the device within direct range of the Z-Wave
controller.
2) Set the Z-Wave controller into adding mode.
3) Move and hold your hand close to the center
of the pad.
4) Loud sound sequence will confirm entering
the menu, keep holding your hand.
5) After hearing two short beeps, take your hand away.
6) Swipe your hand up to confirm selection.
7) Wait for the Z-Wave controller to add the device.
4

ENGLISH

before
Assembling
1) Place the front magnetic cover.
2) Put the Swipe onto its holder.
3) Plug the power source into the micro-USB port
if required.
Configuration
FIBARO Swipe requires configuration to control other
devices. Set response to gestures and sequences
in configuration interface of your Z-Wave network
controller (e.g. Home Center).
Warnings
Failure to observe recommendations included in
the full manual may cause risk to health
or malfunction of the device. The manufacturer, Fibar
Group S.A. will not be held responsible for any loss or
damage resulting from not following instructions of
the manuals.
Do not use batteries or power supply other
than specified.
Specifications
Power supply:
DC supply connector:
Battery type:
Dimensions:
Batteries and/or
5V DC power supply
Micro-USB
4 x 1.5V AA
178 x 130 x 29 mm