User Maintenance Instructions; Cloth Bag & Hose Assembly; Cord Storage - Minuteman 290 Série Manuel D'instructions

USER MAINTENANCE INSTRUCTIONS

All service and repair should be performed by qualified vacuum service representative or electrician.
No user serviceable components are employed in the electrical vacuum lid head assembly. No
lubrication of the motor is required.
CLOTH BAG & HOSE ASSEMBLY
Cloth bag and hose assembly are user maintenance items and can be replaced when worn out.
Cloth bags can be maintained by blowing dust off of the bag and then laundered. Cloth bags
should be completely dried before re-installing into machine. For optimum performance, empty
and clean filter bag regularly. A clogged and dirty bag restricts the flow of air and results in
reduced vacuum. Wet & Dry Models Only, remove the dry dust filter bag. Check the automatic
shut-off to be certain it is working properly. The hose assembly can be maintained by wiping off
with a dampened cloth of mild liquid soap and water, then allowed to dry.

CORD STORAGE

While not in use storage can be accomplished by winding cord around motor lid assembly. Cord
should be completely unwound from lid assembly during operation.
· Do not use with damaged cord or plug. If appliance is not working as it should, has been
dropped, damaged, left outdoors, or dropped into water, return to service center.
· Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp
edges or corners. Do not run appliance over cord. Keep cord away from heated surfaces.
· Do not unplug by pulling cord. To unplug, grasp the plug, not the cord.
· Do not handle plug or appliance with wet hands.
· Always unplug the machine when removing the motor head off the tank. This equipment should
be stored indoors and not exposed to rain.
Parts and Instruction Manual
Page 3