Minuteman 290 Série Manuel D'instructions

Masquer les pouces Voir aussi pour 290 Série:

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

Parts and Instruction Manual
290 Series Vacuums
4 & 6 Gallon

Publicité

Table des Matières
loading

Sommaire des Matières pour Minuteman 290 Série

  • Page 1 Parts and Instruction Manual 290 Series Vacuums 4 & 6 Gallon...
  • Page 2 This manual is furnished with each new MINUTEMAN 290 Vacuum. This provides the necessary operating and preventive maintenance instructions. Operators must read and understand this manual before operating or servicing this machine. This machine was designed to give you excellent performance and efficiency. For best results and minimal cost, please follow the general guidelines below: ·...
  • Page 3 Parts and Instruction Manual...
  • Page 4: Table Des Matières

    Lid Assembly - Wet/Dry ........................7 Lid Assembly - Dry Only ........................8 Tank Assembly ..........................9 Bag Assembly ..........................10 Tools & Attachments ........................11 Wiring Diagram ..........................12 Minuteman International Made Simple Commercial Limited Warranty ........13 Parts and Instruction Manual...
  • Page 5: Important Safety Instructions

    FOR COMMERCIAL USE ONLY IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING WARNING - To reduce the risk of fire, electric shock, or injury: Do not leave appliance when plugged in. Unplug from outlet when not in use and before servicing. WARNING: C29485-05, C29685-06 Wet/Dry 115V C29486-05, C29686-06 Wet/Dry 240V...
  • Page 6: Inspection

    INSPECTION Carefully unpack and inspect your machine for shipping damage. Each unit is tested and thoroughly inspected before shipment, and any damage is the responsibility of the delivery carrier who should be notified immediately. ELECTRICAL - 115 Volt This machine is designed to operate on a standard 15 amp. 115 volt, 60 hz, AC circuit. Voltages below 105 volts AC or above 125 volts AC could cause serious damage to the motor.
  • Page 7: User Maintenance Instructions

    USER MAINTENANCE INSTRUCTIONS All service and repair should be performed by qualified vacuum service representative or electrician. No user serviceable components are employed in the electrical vacuum lid head assembly. No lubrication of the motor is required. CLOTH BAG & HOSE ASSEMBLY Cloth bag and hose assembly are user maintenance items and can be replaced when worn out.
  • Page 8: Bien Lire Le Modes D'emploi Avant Usage

    POUR USAGE COMMERCIAL SEULEMENT MODE D’EMPLOI SECURITAIRE Lorsque l’on utilise un appareil électrique, des précautions de base doivent toujours être suivies telles que: BIEN LIRE LE MODES D’EMPLOI AVANT USAGE AVERTISSEMENT - Pour réduire les risques de feu, choc électrique ou blessure: Ne pas quitter l’appareil lorsque la prise de courant est branchée.
  • Page 9: Instructions Pour Prisse De Terre

    INSPECTION Déballer soigneusement et inspecter la possibilité de tout dommage apparent. Chaque machine est complètement inspectée á l’usine et les dommages de transit sont la responsabilité de la compagnie de transport qui devrait être prévenue immédiatement. ELECTRICITE Cette machine est concue pour opérer sur un circuit standard de 15 amp. 115 volt, 60 hz, circuit AC.
  • Page 10: Instructions A L'utilisateur

    INSTRUCTIONS A L’UTILISATEUR Toute réparation ou entretien doit être fait par un représentant de service qualifié ou un électricien. Aucune pièce de la tête de l’aspirateur ne nécessite d’entretien de la part de l’utilisateur. Aucune lubrification du moteur n’est requise. SAC FILTRANT REUTILISABLE ET MONTAGE DU BOYAU Le sac filtrant réutilisable et le montage de boyau sont des items devant être entretenus par...
  • Page 11: Exploded Views

    Exploded Views Lid Assembly - Wet/Dry Parts and Instruction Manual Page 7...
  • Page 12: Lid Assembly - Dry Only

    Lid Assembly - Dry Only Parts and Instruction Manual Page 8...
  • Page 13: Tank Assembly

    Tank Assembly Item Part No. Qty. Description Item Part No. Qty. Description 390087 Gasket Diecut VNN 712320 WSR .20x.45x.048 NYL 390110 Intake Assy. Aluminum 712638 Hex Nut 10/24 SS Nyloc 460110 Tank 6 Gal. High Intake 712764 Washer #10 SS 460111 Tank 4 Gal.
  • Page 14: Bag Assembly

    Bag Assembly Item Part No. Qty. Description 760244 Bag Ring 4/6 PV Black 805043 Bag Only 4G 805040 Bag Only 6G 805044 Bag Assy 4G 805041 Bag Assy 6G Parts and Instruction Manual Page 10...
  • Page 15: Tools & Attachments

    Tools & Attachments Part No. Description 800083 3" Rd Dust Brush Complete 133249 Dust Brush HSG 3" 800084 Bristle Insert 3" 808023 Adapter 800035 12" Crev Tool Complete 290000 Wand Assy 1-1/2, Complete 290001 Wand - Upper 290002 Wand - Lower 800317 Hose Asy 1-1/2 x 10' 390014...
  • Page 16: Wiring Diagram

    Wiring Diagram Parts and Instruction Manual Page 12...
  • Page 17: Minuteman International Made Simple Commercial Limited Warranty

    A potential health hazard exits without original equipment replacement. All warranted items become the sole property of Minuteman or its original manufacturer, whichever the case may be. Minuteman disclaims any implied warranty, including the warranty of merchantability and the warranty of fitness for a particular purpose.

Ce manuel est également adapté pour:

C29485-02C29486-05C29486-00C29485-05C29685-06C29686-06

Table des Matières