Retekess T-AC03 Mode D'emploi page 8

To add a card and PIN user in card and PIN mode (
To Add a card and PIN user
(The PIN is any four digits between 0000
& 9999 with the exception of 1234 which
is reserved.)
To change a PIN in card and PIN mode
(Method 1) Note that this is done outside
programming mode so the user can
undertake this themselves
To change a PIN in card and PIN mode
(Method 2) Note that this is done outside
programming mode so the user can
undertake this themselves
To delete a Card and PIN user just delete
the card
To add a card user in card mode (
To Add and Delete a card user
To delete All users
To delete ALL users. Note that this is a
dangerous option so use with care
To unlock the door
For a PIN user
For a card User
For a card and PIN user
2. Door Settings
Relay Output Delay Time
To set door relay strike time
Door Open Detection
Door Open Too Long (DOTL) warning. When used with an optional magnetic contact or built-in
magnetic contact of the lock, if the door is opened normally, but not closed after 1 minute, the
inside buzzer will beep automatically to remind people to close the door and continue for 1
minute before switching off automatically.
Door Forced Open warning. When used with an optional magnetic contact or built-in magnetic
contact of the lock, if the door is forced open, or if the door is opened after 20 seconds ,the
inside buzzer and alarm output will both operate. The Alarm Output time is adjustable between
0-3 minutes with the default being 1 minute.
3
Add the card as for a card user
Press
*
Then allocate the card a PIN as follows:
Read card 1234 # PIN # PIN #
*
Read Card
*
New PIN #
ID number #
*
New PIN #
2 User ID
)
3 0 #
The operating is the same as adding and deleting a
card user in
2 0000
Enter the PIN
Read card
Read card then enter PIN #
Master code #
*
0-99 is to set the door relay time 0-99 seconds
6
)
1 #
to exit from the programming mode
Old PIN #
Old PIN #
#
3 2 #
#
then press #
4 0～99
New PIN #
New PIN #
# *