Retekess T-AC03 Mode D'emploi page 7

To add a user in either card or PIN mode, i.e. in the
To add a Pin user
To delete a PIN user
To change the PIN of a PIN user
(This step must be done out of
programming mode)
To add a card user (Method 1)
This is the fastest way to enter cards,
user ID number auto generation.
To add a card user (Method 2)
This is the alternative way to enter cards
using User ID Allocation. In this method a
User ID is allocated to a card. Only one
user ID can be allocated to a single card.
To add a card user (Method 3)
Card number is the last 8 digits printed
on the back of the card,user ID number
auto generation
To add a card user (Method 4)
In this method a User ID is allocated to a
card number. Only one user ID can be
allocated to the card number
To delete a card user by card. Note users
can be deleted continuously without
exiting programming mode
To delete a card user by user ID. This
option can be used when a user has lost
their card
To delete a card user by card number.
This option can be used when the user
want to make the change but the card
has lost
3 2
1 User ID number
The ID number is any number between 1 & 2000.
The PIN is any four digits between 0000 & 9999
with the exception of 1234 which is reserved. Users
can be added continuously without exiting
programming mode as follows:
1 User ID no 1
PIN #
2 User ID number
Users can be deleted continuously without exiting
programming mode
* ID number #
New PIN #
1 Read card #
Cards can be added continuous exiting programming
mode
1 ID number # Read card #
User can be added continuously without exiting
programming mode
1 Card number
User can be added continuously without exiting
programming mode
1 ID number. #
User can be added continuously without exiting
programming mode
2 Read Card
2 User ID #
2 Card number
Note users can be deleted continuously without
exiting programming mode
5
# mode. (Default setting)
# PIN #
# PIN # User ID no 2 #
#
Old PIN # New PIN #
#
Card number. #
#
#