Important Instructions For Use - therm-ic I-Pack Mono button B Mode D'emploi

INSTRUCTIONS FOR USE / ENGLISH
Turning the device ON:
Press and hold down the function button (1.2)
(for approx. 3 seconds) to set the Therm-ic
Boot Integration System to the lowest heating
level. If the button is pressed for more than
6 seconds, the boots will go into lock mode
and switch off.
Changing the heat setting:
Pressing the function button once (for approx.
1 second) will increase the heating setting
(level 1, level 2 or level 3).
> Level 1: 1 flash, low heating setting.
> Level 2: 2 flashes, medium heating setting.
> Level 3: constant light, high heating setting.
Turning the device OFF:
To switch off the Therm-ic Boot Integration
System, press and hold the function button
(1.2) (for 3 seconds, until the heating level
indicator light switches off).

IMPORTANT INSTRUCTIONS FOR USE

• Charge the batteries before each use.
• When switching on the Therm-ic Boot
Integration System, do not leave them set
to level 3 for more than a few minutes;
continuous use at this setting risks raising
the temperature excessively and may cause
burns.
• Always set the Therm-ic Boot Integration
System to the level 1 or level 2 setting to
keep your feet at a comfortable temperature
(the warming effect should be practically
imperceptible).
• The optimum heating temperature is reached
when the boots are dry.
11