Camozzi F Série Instructions D'utilisation Et De Maintenance page 30

93-7507-0014
Use and maintenance instruction
Valves series F
Revision B
6.3 To change or add a valve:
1
2
3
A – Remove the cover of the tie rod (1)
B – Unscrew the screws (2) on the right side (opposite at the D-sub connector). To avoid undesirable
mechanical stress on plastics and ties is advisable to loosen both screws before complete removal
C – Open the valves island to release the valve (3)
D – Turn the valve and unhook it from the tie rod
E – Repeat the D instruction in the opposit sequence to mount the new valve
F – Close the valve Island and reassemble the cover of the tie rod (1)
ATTENTION: the torque force of the screws (2) should be 1 Nm