Operating Instructions - Sticker Mule LMD03 Manuel D'utilisation Et D'entretien

6. Operating instructions

• Insert the power jack plug
dedicated socket
plug to the electrical socket.
• Before turning on the device, load the roll of labels fol-
lowing the procedure described in chapter 7.
• Press the power button
device will make three acoustic signals of increasing
volume to warn that the dispenser is ready for use and
both LEDs will be lit.
• The switched on device will be in MANUAL mode. To
change the MANUAL/AUTOMATIC mode, see chapter 10
"Mode of operation".
• Configure the optical sensor (see chapter 9).
• To peel the label in MANUAL mode, press button
• Once the label has been removed, press button
again for the next label.
• In case of AUTOMATIC mode, press button
peeling. Once the label has been removed, the dispenser
will peel off the next label.
⓬
as far as it goes into the
❶
and connect the power supply
❷
to start the device. The
❸
.
❸
❸
to start
English | 9
EN
FR
ES
DE
IT