Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8. Motor housing
9. Dust lid
10. Drip stop control
Initial use
Preparation
•
Clean the appliance. Refer to the section
"Cleaning and maintenance".
Assembly (fig. A)
Warning!
-
Before assembly, remove the mains plug
from the wall socket and wait for the motor
to stop running.
•
Place the motor housing (8) onto the jar
(1). Make sure that the drip stop control
(10) is fully pressed by the jar (1).
•
Place the juice collector (7) onto the motor
housing (8).
•
Place the pulp collector (6) onto the juice
collector (7).
•
Place the small pressing cone (4) onto the
pulp collector (6).
•
If required, place the large pressing cone
(5) onto the small pressing cone (4).
Use
Hints for use
Warning!
- Do not leave the appliance switched on
continuously for more than three minutes.
- Let the appliance cool down for
approximately five minutes after every ten
pressings.
•
Assemble the juicer. Refer to the section
"Assembly".
•
Cut the citrus fruit in half.
•
Place the cut surface of one half onto the
pressing cone:
- For small citrus fruits (lemons, limes, etc.),
use the small pressing cone.
- For large citrus fruits (oranges, grapefruits,
etc.), use the large pressing cone.
•
Press the citrus fruit with one hand. The
appliance automatically starts to press the
citrus fruit. The juice automatically flows
into the jar.
•
Press the citrus fruit until hardly any more
juice is extracted from the citrus fruit. The
appliance automatically stops when the
pressure is released.
Note: The appliance automatically changes
direction when it is switched off and on in
order to increase the amount of juice being
extracted.
•
Stop pressing the citrus fruit in one of the
following situations:
- no more juice is extracted from the citrus
fruit;
- the jar is filled with the required amount
of juice;
- the jar has reached the maximum
capacity.
•
Remove the motor housing from the jar.
•
Use the jar lid according to the situation:
- If you use the appliance within a short
period of time, place the jar on the jar lid
to prevent the jar from turning accidentally.
- If you do not use the appliance within a
short period of time, place the jar lid onto
the jar.
•
After use, remove the mains plug from the
wall socket.
Cleaning and maintenance
The appliance must be cleaned after each use.
Warning!
- Before cleaning or maintenance, remove
the mains plug from the wall socket and
wait for the motor to stop running.
-
Do not immerse the appliance in water or
other liquids.
Caution!
- Do not use aggressive or abrasive cleaning
agents to clean the appliance.
- Do not use sharp objects to clean the
appliance.
-
Do not clean the appliance in the dishwasher.
It is not recommended to wash the
removable parts of the appliance or the
accessories in a dishwasher.
5
Publicité
Table des Matières
