ageLOC GALVANIC SPA Manuel Du Propriétaire page 8

EN
Galvanic Spa Facial Gels
with ageLOC
Pre-Treat Setting
Use this regimen three-times each week for visibly revitalising
& refreshing results.
Preparation: Use after a Nu Skin ® cleanser
of your choice. Attach the ageLOC Face
Conductor to the device (Figure 1).
Figure 1
PRE-TREAT GEL PHASE
1: Evenly apply an entire ampoule of
step
ageLOC Pre-Treat Gel to the entire face
and neck, avoiding eyes, eyelids, and lips.
2: Push the selection button until the
step
Figure 2
number 1 is lit on the display (Figure 2). This
application will take 2 minutes.
3: Thoroughly wet hands with NaPCA
step
Moisture Mist or water. Hold the device with
a moistened hand while touching the chrome
plate on the back and begin to slowly glide the
conductor head over your skin (Figure 3). Be
sure to avoid sensitive areas like your eyes,
Figure 3
eyelids, and lips.
The device will beep once, twice, or three times to indicate that
it has automatically adjusted to your skin. After this, your galvanic
application has begun, and the device will beep every 10
seconds to indicate the unit is on and working, and every 5
seconds when your application is almost complete.
12
Treatment Setting Conductor
GS 1
PRE-TREAT GEL
4: When your galvanic application
step
is over, the device will emit a long beep
followed by two short beeps and
automatically turn off. Remove any
remaining gel from your skin and the
device with a damp towel (Figure 4).
Now it ' s time for the Treat Gel phase.
TREATMENT GEL PHASE
1: Apply an entire ampoule of
step
ageLOC Treatment Gel to your face and neck.
2: The ageLOC Face Conductor should already be
step
attached, so press the selection button once to turn the
device back on and keep pressing until you
select application number 2 (Figure 5).
This application will take 3 minutes.
3: Again, hold the device with a
step
moistened hand while touching the chrome
plate on the back, and begin to slowly glide
the conductor head over your skin (Figure
6). Be sure to avoid sensitive areas like your
eyes, eyelids, and lips.
The device will beep one, two, or three
times to indicate that it has automatically
adjusted to your skin. After this, your galvanic
application has begun, and the device will
beep every 10 seconds to indicate the unit is
on and working, and every 5 seconds when
your application is almost complete.
4: When your galvanic application is over, the device will
step
emit a long beep followed by two short
beeps and automatically turn off. Use a
damp towel to remove any remaining gel
from your skin and the device (Figure 7).
EN
Figure 4
GS 2
TREATMENT GEL
Figure 5
Figure 6
Figure 7
13