ageLOC GALVANIC SPA Manuel Du Propriétaire page 4

EN
ageLOC Galvanic Spa
Contents
1 Owner ' s Manual
2 ageLOC Galvanic Spa Device
ageLOC Face Conductor
3
4 Focus Area Conductor
Body Conductor
5
6 Scalp Conductor
Two AAA Batteries
7
1
®
AGELOC ®
GALVANIC SPA
®
Owner ' s Manual
3
5
7
- AAA +
The personal care products designed for use with ageLOC
Galvanic Spa are sold separately.
4
2
4
6
- AAA +
Important Maintenance and
Warranty Information
Cleaning Your Device and Conductors:
After finishing a galvanic application,
remove the conductor from the device
and use a damp cloth to clean off any
excess product (Figure 1). Dry the
device thoroughly and store in a dry
Figure 1
place without a conductor attached.
Directions for Changing Batteries:
When the batteries are low, an amber
battery icon will appear in the middle
of the display and the device will beep
four times twice (Figure 2). When this
happens, install two new AAA batteries.
Figure 2
To replace the batteries, push just above
the battery compartment cover on each
side and pull down firmly (Figure 3).
The battery cover will separate from the
FACIAL SPA
device (Figure 4).
Next, pull gently on the ribbon and
remove the old batteries. Insert two new
AAA batteries into the compartment
and over the ribbon. Failure to tuck the
Figure 3
ribbon under the batteries may allow
water to leak into the device, resulting in
damage to the device (Figure 5).
Finally, slide the battery cover firmly
back in place (Figure 6).
Figure 4
Figure 5
EN
Figure 6
5