Storage; Display Error Codes - Predator D12WIFI Mode D'emploi

If the dehumidifi er will not be used for a long period of time, take the following steps:
1- Remove the plug from the socket and empty the tank, make the tank and the dehumidifi er dry completely, this
may take a couple of days.
2- Clean the air fi lter .
3- Check the dehumidifi er for perfect condition to ensure a safe use of it after a long period of storage.
4- Pack the device with the suitable packaging.
5- Store the dehumidifi er in a dust-free and out of direct sunlight location, preferably covered with a sheet of
plastic.
Please contact local distributor if any of the error codes below appears.
Display Code
Error
Display
What is happening
www.glaziar.com / info@glaziar.com

STORAGE

DISPLAY ERROR CODES

E1
Temperature sensor Humidity sensor error
error
Flash every 30
seconds
Machine works
normally
E2
Air inlet temperature is
Flash every 30
seconds
Machine works
normally, but can't working, fan works
set the humidity
decrease to below
40
L3
Air inlet temperature is
too high>42 0 C
Slowly fl ash L3
Compressor stop Compressor stop
working, fan works
at low fan speed. at low fan speed.
10mins later, if 10mins later, if the
the temperature temperature increase
0
C, machine will machine will work
work normally.
L4
0 0
too low< C
Slowly fl ash L4
to above 2 0 C,
normally
36