Publicité
Les langues disponibles
Les langues disponibles
1. Features
The Mistral membrane air pumps are designed for universal use. The housing is made from cast
aluminium and this, combined with the magnetic control system and the vibration reducing rubber
feet, results in exceptionally quiet operation.
IMPORTANT NOTE:
The pump must only be operated at the correct voltage (see type label).
2. Technical Data
Power requirements:
Power uptake:
Maximum capacity:
Capacity at 1 m (3 ft) depth (100 mbar,
1.45 psi)
Maximum pressure:
Connection pressure side:
Cable length:
Weight:
Housing:
2500
2250
2000
1750
1500
1250
1000
750
500
250
0
0
0,05
Capacity of the Mistral 2000
3. Connections
The pump is connected to the equipment it supplies via an air hose (12 mm, ½"). If ozone is to be
used, ozone resistant tubing (e. g. silicone) must be used. When operating several consumers the
distributor provided can be used. 10 consumers can be attached via a 6/4 aquarium air hose.
4. Installation
The pump should be positioned in a dry place. Care should be taken to ensure that water cannot enter
the pump when, for instance, it is switched off for aquarium maintenance or during a power failure.
There are two methods of installation:
-
above the water level – see fig. A below
-
below the water level. In this case a reliable non-return valve must be fitted in the air line. – see
fig. B below
Mistral 2000
220/240 volts ~ 50/60 Hz
25 watts
2,500 litre/hour,
(approx. 625 gph)
1,600 litres/hour (400 gph)
>300 mbar, 4.35 psi
air tube 12 mm (½")
3 m
3,5 kg (7,8 lbs)
cast aluminium
0,1
0,15
0,2
Druck (bar)
0,25
0,3
0,35
5
Publicité
