Operating Your Appliance; Temperature Control; Defrosting Your Freezer - Avanti CFC244H0W Manuel D'instructions

OPERATING YOUR APPLIANCE

Ø Setting the Temperature Control
·
To control the internal temperature, adjust the
control dials according to the ambient temperature or
purpose of use.
·
The first time you turn the unit on, set the
temperature control to "5".
·
The range of the temperature control is from position
"1" the warmest to "5" the coldest in the freezer
section. After 24 to 48 hours, adjust the temperature
control to the setting that best suits your needs. The
setting of in the 3should be correct for regular use.
NOTE:
§
IF THE UNIT IS UNPLUGGED, HAS LOST POWER, OR IS TURNED OFF, YOU MUST WAIT 3
TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO RESTART BEFORE
THIS TIME DELAY, THE REFRIGERATOR-FREEZER WILL NOT START.
NOTE:
·
Turning the temperature control to "OFF " position stops the cooling cycle but does not shut off the
power to the freezer.
·
If the unit is unplugged, lost power, or turned off; you must wait 3 to 5 minutes before restarting the
unit. If you attempt to restart before this time delay, the freezer will not start.
·
Large amounts of food will lower the cooling efficiency of the appliance.
·
If you choose to change the thermostat setting, adjust thermostat control by one numerical
increment at a time. Allow several hours for temperature to stabilize between adjustments.
Ø Defrosting Your Freezer
· When? For the most efficient operation and minimum energy consumption, defrost the freezer
when the frost on the freezer walls is excessive or ¼ to ½ inch thick.
· Choose a time when the stock of frozen food is low.
CAUTION
Do not use boiling water because it may damage the plastic parts. In addition, never use a
sharp or metallic instrument to remove frost as it may damage the cooling coils and will void
the warranty. We recommend using the plastic scraper provided with your unit.
·
Remove the frozen food from the freezer and place it in a cooler to protect the food.
·
Turn the thermostat knob to "OFF".
·
During defrosting, the ice melts into the cabinet.
·
Remove the drain plug on the inside floor of the freezer by pulling straight out.
·
Place a shallow pan outside drain outlet. Rotate the drain dial 180 degrees and pull outward.
This will allow the water to flow freely to the pan.
·
Check the pan occasionally so the water does not overflow.
·
Clean the interior of the freezer.
·
Replace the plug on the inside floor.
·
Replace the outside drain dial.
·
Reset the thermostat to desired setting.
·
Allow the cabinet to cool for one hour.
·
Return food to the freezer.
9