General Guidelines - Velleman SHE16 Notice D'emploi

Masquer les pouces Voir aussi pour SHE16:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8

3. General Guidelines

Refer to the Velleman
manual.
Protect this device from shocks and abuse. Avoid brute force when operating the
device.
Protect the device against extreme heat and dust.
Familiarise yourself with the functions of the device before actually using it.
Damage caused by user modifications to the device is not covered by the
warranty.
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered by
the warranty and the dealer will not accept responsibility for any ensuing defects
or problems.
4. Overview
Refer to the illustration on page 2 of this manual.
A heart beat indicator
B 3-digit display
C START/STOP button
D distance unit
5. Set-up
Refer to the illustration on page 2 of this manual.
Note: if in setup mode nu button is pressed for 60 seconds, the device will go into
standby mode and all default values are applied.
Press and hold START/STOP [C] and MODE [G] simultaneous for ±5s to reset and
enter setup mode.
The display shows CL CL CL CL (clock,) and ON
heart rate measurement. To switch the clock OFF
Press MODE [G] and set the minutes with START/STOP [C].
Press MODE [G]to confirm and set the hour with START/STOP [C].
Press MODE [G] to confirm and select the stopwatch time limit with START/STOP
[C]. Available options: 10, 30 (default) min, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10 h. When
expired an alarm will sound.
Press MODE [G] and set heart rate measuring time (HP HP HP HP) with START/STOP [C].
Available options: 1 (default), 3, 10, 20, 30 min, 1h. When expired an alarm will
sound.
Press MODE [G] and set heart rate lower limit (Min) with START/STOP [C]. Range
from 30~194, default 50. When exceeded an alarm will sound.
Press MODE [G] and set heart rate upper limit (Max) with START/STOP [C]. Range
from 55~199 (step 5), default 150. When exceeded an alarm will sound.
Press MODE [G] and set your step length with START/STOP [C]. Range from
15~150cm, default 45cm. To determine your step length, choose a mark on the
floor, place your heel on the mark and take a number of steps. Measure the
®
Service and Quality Warranty on the final pages of this
E MODE indicator: stopwatch, step, calorie, distance
F 5-digit display
G MODE button: heart rate, stopwatch, step, calories,
distance
H max/min indicator
ON. This indicates that the clock is shown during
ON ON
SHE16
OFF, press START/STOP [C].
OFF
OFF

Publicité

Table des Matières
loading

Table des Matières