miniland baby warmyplus digy Mode D'emploi page 17

8. Push the power button
which indicates the sterilisation cycle in progress (15) will illuminate with a green
colour, and the device will commence operation.
NOTE 1: The steam which is released during the sterilisation process is very hot.
The device must not be touched whilst it is being used.
NOTE 2: If you wish to temporarily interrupt the sterilisation process, push the power
button (13). To restart the process, push the same button again.
If, however, you wish to terminate the sterilisation process completely before the time
indicated runs out, keep the power button
9. Once the sterilisation process has been completed, the device will beep and the
process status indicator (15) will turn itself off to notify the user.
10. Given the high temperatures which could be reached, remove the sterilised parts
very carefully to avoid burns.
NOTE 3: Allow the steriliser to cool down for at least 20 minutes before sterilising again.
5.4. LOCATING FAILURES
SYMPTOMS
The screen is turned off
The screen flashes and an alarm
sounds
The device has reduced
effectiveness when heating
The device works but it does not
heat up
Other malfunctions
6. MAINTENANCE
Follow the instructions below for any maintenance tasks:
• The device itself (main body):
∙ Always power the device down and unplug it before proceeding with any cleaning
tasks.
∙ Only use a damp cloth to clean it.
• The device itself (heating chamber):
∙ Depending on the quality of the water used, lime deposits may build up over time at
the base of the heating chamber. These lime deposits must be removed regularly by
pouring a mixture of 100 ml of hot water and 100 ml of white vinegar into the heating
chamber. Pour directly into the basin and allow to soak for around 30 minutes.
Subsequently, empty the receptacle and wipe it with a damp cloth.
∙ There are specific products on the market for removing lime from this type of device;
they can also be used to clean it. In any case, before using them, make sure that
they are not abrasive.
(13) again to start the process. Following this, the LED
(13) pushed down for four seconds.
POSSIBLE CAUSES AND CORRECTIVE
Check that the device is plugged in and
push the power button.
There is not enough water in the heating
chamber. Replenish it and restart the
process.
Check if there are any lime deposits in the
heating chamber. Clean the chamber by
following the instructions in point 6 as many
times as may be necessary nor normal
operation to be restored
Get in touch with the Miniland technical
service
17
ENGLISH
MEASURES