Operation
Fig.
Switching on/off
4
The product can only be switched on
or into Standby. Unplug in order to
disconnect from the mains.
Press the on/off button
OFF button to switch the product on or
into standby.
Note:
• After a power break or when the product
is switched into standby and on again in
a short time, the refrigerating compressor
will resume work after 3 minutes (delayed
start). This is to prevent the cooling circuit
from damages.
• If the product is tilted over, switch it into
standby and unplug immediately. Wait
at least 2 hours before operating the
product again to avoid damages on the
refrigerating circuit.
• Always switch the product into standby
before unplugging.
Remote control
Fig.
Remove the battery compartment cover.
5
Insert 2 batteries (type R03/ AAA) while
paying attention to the correct polarity.
Close the battery compartment. Using
the control panel and the remote control
alternately might lead to a misalignment
of the product and the information
displayed on the remote control.
Note:
• Press any button on the remote control
and the product adopts the current
setting from the remote control.
• The signals of the remote control will
be transmitted with a short delay after
a button is pressed. This process is
indicated by the appearing
the remote control display.
• Every press of a button on the remote
control will illuminate the display on the
remote control for a few seconds for
better visibility in the dark.
IM_KAC3232_KAC3352_181220_V04_HR.indb 45
Control
panel
+
or the ON/
MODE
FAN
SLEEP
SWING
—
TIMER
—
—
symbol on
Remote
Function
control
Switch on or into
ON/OFF
standby
Increase value, e.g.
TEMP
temperature or timer
Decrease value of
TEMP
temperature or timer
Mode selection button
MODE
Fan speed selection
FAN
button
Sleep mode on/off
SLEEP
Fan outlet oscillation
SWING
on/off
Display and indicator
LED
lights on/off
Adjust switch into
TIMER
+
standby time
OFF
on
–
off
TIMER
Adjust switch on time
ON
Choose preset mode
SHORT
and temperature
CUT
Precise temperature
FOLLOW
control
ME
English
45
20/12/18 4:15 pm