General Safety Regulations - Holmatro GRA4321 Mode D'emploi

EN
2.2 Model plate and CE marking on the equipment
See Fig. 1.
All pictograms attached to the equipment pertaining to safety and danger must be complied with and
remain clearly legible.
WARNING
Not following these instructions can result in serious personal injury, fatal accident, damage
to the system or consequential loss.
/i
Type of mark Pos.
Prohibition A
Information B
Instruction C
Instruction D
Model plate E
If the pictograms are illegible, have the pictograms replaced by a Holmatro Certified Technician.
2.3

General safety regulations

• Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
• Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
• Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Except for electrical
parts, rinse parts that have come into contact with corrosive acid or liquid with a lot of water. Consult
your Holmatro dealer for a resistance list.
• Prevent dirt in and on the couplers.
• Protect equipment against sparks during welding or grinding activities.
• Avoid an unhealthy posture while working. It can result in physical complaints.
• Follow the inspection and maintenance instructions.
• Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
• Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.4 Personal safety
Rescue personnel must wear all personal means of protection as prescribed in the standard work
procedure. Negligent use of personal means of protection can result in serious injury. During use wear
at least the following personal means of protection:
30
Description
Do not load the ram head from its centre.
Information about the usable length.
• Read the user manual before use.
• Wear a helmet.
• Wear safety goggles.
• Wear safety gloves.
• Wear protective clothing that covers the
entire body.
• Wear safety shoes.
Danger of jamming parts of the body.
Manufacturer's information stating: name,
address, CE marking, model indication, serial
number and date of construction, maximum
operating pressure.
916.001.324_000
Part no.
920.299.568
920.000.383 (GRA4321)
920.000.384 (GRA4331)
920.299.572
920.000.042
-
GRA4321 / GRA4331