Tannoy VLS 7 Guide Rapide page 6

10 VLS PAN/TILT BRACKET
Bracket Installation
1. Prepare the bracket by separating the two parts of the bracket by removing bolt "C" as shown on Fig.1.
2. Attach the bracket to the wall using suitable wall fi xings. Ensure that the support slot is at the top.
Use all 6 fi xing holes to ensure that the load is spread evenly.
3. Fix the bracket to the loudspeaker using the included screws and washers.
Mounting the loudspeaker on the wall bracket
1. Lift the loudspeaker up to the wall bracket and insert the tilt rod "A"
of the bracket into slot "B" at the top of the wall bracket.
2. The weight of the bracket is now supported.
3. The bottom fi xing bolt "C" can now be fi tted.
4. The bracket is now secure and can be adjusted to the required angle.
Adjusting the pan and tilt
Pan
1. Loosen the vertical bolt "D" on the wall bracket using a spanner
(wrench) on the top and bottom.
2. Adjust to desired angle then re-tighten vertical bolt "D".
Tilt
1. Loosen bolts "E" and "F" on the loudspeaker bracket using a spanner
(wrench) and the supplied Allen key.
2. Adjust to desired angle then re-tighten bolts "E" and "F".
Bracket pan and tilt angles
VLS 7
Tilt 0-10°
Pan left and right with no tilt 70°
Pan left and right with full tilt 45°
VLS 15 VLS 30
0-10° 0-10°
70° 70°
45° 45°
11 Quick Start Guide
Specifi cations
VLS PAN/TILT BRACKET
Hardware (screws, nuts and washers) Stainless steel
Bracket material Aluminium and steel with corrosion-resistant nickel zinc fi nish
Colours Black Ral 9004 or White Ral 9003