Connecting The Connection Cable - Waeco MagicSafe MS670 Instructions De Montage Et De Service

_MS-670.book Seite 42 Donnerstag, 8. Mai 2008 4:55 16
Connecting the electrical power to MagicSafe
7.1 Laying cables
When laying the cables, make sure:
They are not kinked or twisted
They do not rub on edges
They are not laid in sharp edged ducts without protection (fig. 3,
page 4).
a
Caution!
Before drilling any holes, make sure no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing
(fig. 2, page 4).
➤ When laying cables in the engine compartment or boot, use existing
openings with rubber seals wherever possible.
Where there is no suitable opening, drill a hole with a diameter of
approx. 13 mm and insert a cable duct sleeve.
I
Note
Pull the socket connectors of the cables through the cable duct
sleeve, before inserting the sleeve in the bodywork.
➤ Lay out the cables in the motor or boot so that they cannot be damaged
under any circumstances (e. g. by flying grit).
➤ Insulate all unused cable ends.
7.2

Connecting the connection cable

➤ Insert the plug of the connection cable into the corresponding connection
on the control unit (fig. 5 2, page 5).
42
MagicSafe MS670