Operations And Features; Using The Remote Control; Using The Control Panel - Signature Design by Ashley EF30-30A Manuel De L'utilisateur

Foyer
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATIONS AND FEATURES

Using the Remote Control

Power
This will turn the unit ON and OFF.
When it is turn OFF, the fan will
continue to run after turning off the
heating function to cool and protect
the unit from overheating up to a
period of 3 minutes
When the unit is
.
turned back ON, the system will
recall the last heat setting used.
Store flame and Heating setting.
Adjust Brightness
This allows you to raise or lower
the level of flame brightness.
Note: when the unit is turned off
that the LOGS completely die out
for 3 seconds.
Timer
This allows you to set the
fireplace to automatically shut
OFF after the amount of time
displayed on the screen, the
timer can be set from 10
minutes to 9 hours, the display
shows 10, 20, 30, 40, 50, 1H, 2H,
3H, 4H, 5H, 6H, 7H, 8H, 9H. Do
not operate fireplace while
unattended.

Using the Control Panel

Timer/Dynamic Embers
This will allow you to set the
automatic shutoff on the
fireplace. Dynamic Embers
will work on the unit hold 5
seconds when beeps press
again. To stop embers press
timer button then hold for 5
seconds.
EF30-30A
MODEL#:
Adjust Temperature
This allows programming
of the thermostat. The
fireplace can be used
without the heater if
desired. Simply cycle
through the function until
no temperature is
displayed. Press and hold
the button for five seconds
to switch temperature
readout from
(Fahrenheit) and
(Celsius) and back.
Adjust Temperature
This allows programming of
the thermostat. The fireplace
can be used without the heater
if desired. Simply cycle through
the function until no
temperature is displayed. Press
and hold the down arrow for
five seconds to switch
temperature readout from
(Fahrenheit) and
and back. Must be in Heat
mode.
This function will make the
embers of the fire
automatically glow dimmer and
brighter creating a more
realistic fire effect.
Adjust Brightness Power
This function will cycle
through the five
different levels of flame
brightness.
(Celsius)
Dynamic Embers
This will turn the unit ON
and OFF. When the unit is
turned back ON, the system
will load default factory
settings.
Page 8 Of 13

Publicité

Table des Matières
loading

Table des Matières