Senix CS4QL-L1 Manuel D'instructions page 15

WARNING
The choke knob should be switched to "RUN" position
immediately by pressing the throttle trigger after cold
start, otherwise the engine could be damaged due to
continuous running with closed choke.
Note: When the engine is running with no load at
high speed, you may hear the engine speed limiter
controlling maximum RPM.
The sound is normal. When saw is under load cutting,
the sound will become steady.
Start with warm engine
Press primer bulb 5 times until gas is visible in the
primer bulb and fuel line. (Fig. 10)
WWW.SENIXTOOLS.COM
Fig. 8
Fig. 9
x5 x5
Pull the choke knob all the way out to FULL CHOKE
position.
Push the choke knob in. The choke is now in the Run
position.
Fig. 10
Fig. 11
Fig. 12
15