Sonnenkonig VENTUS 250 Mode D'emploi page 47

The heating element is glowing
The appliance does not heat up,
only the ventilator works
Abnormal noise
The input voltage is too high or
too low
The air inlet grille is blocked
The switch was not turned to set
the heat
The thermostat is active
The self-resetting cut-out was
activated
The appliance does not stand
upright
47
Use power supply according to
the rating on the label
Keep the heater far away from
objects like curtains, plastic
bags, paper and other things
which can easily cover the air
inlet
Turn the switch to set the heat
Turn the thermostat and
listen if there is an open/close
noise. If there is no click and the
thermostat is not damaged, the
heater will automatically switch
on when the appliance has
cooled down.
Turn the heater off and inspect
the blockage of the inlet or the
outlet. Disconnect the plug
and wait at least 10 minutes for
the protection system to reset
before attempting to restart the
heater.
Put the heater on a level surface
EN