Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3 Applications
GB
This converter will convert composite signals of any
video sources (e. g. cameras, video multiplexers,
video recorders, DVD players or games consoles) into
a VGA signal and display them on a PC monitor.
The converter also has a feed-through output, e. g.
to connect a video recorder or an additional video
monitor.
Settings such as brightness, contrast, tint, colour,
resolution and frequency are made via OSD menu.
4 Mounting and Connecting
Via its two mounting brackets (6), the converter can be
mounted by means of screws, e. g. to a wall. To set up
the unit, glue the rubber feet supplied to the lower side
of the unit.
Always switch off the units before making or chang-
ing any connections.
1) Connect the video source to the jack VIDEO IN (7).
2) Connect the VGA monitor to the jack VGA OUT (9).
3) If required, connect an additional video monitor or
video recorder to the feed-through output VIDEO
OUT (8). At the jack, the same signal will be present
as at the input VIDEO IN. It will not be affected by
the settings of the converter.
4) Connect the plug-in power supply unit provided to
the low voltage jack "5 V /1.2 A" (10) and to a mains
socket (100 – 240 V~/ 50 – 60 Hz). Thus, the unit is
switched on; the POWER LED (1) will light up.
5 Operation
If a video signal is present at the input VIDEO IN (7),
the LED SIGNAL (2) will light up.
5.1 Settings in the OSD menu
To change the converter settings, activate the main
menu with one of the three buttons (3 – 5). When the
OSD menu is inserted and no button is pressed for
more than approx. 10 s, the menu will disappear auto-
matically.
The main menu:
–––––––––––––––––––––––––––––
Picture
Features
Resolution
Exit
8
Main Menu
Select the desired submenu with the button
(5) and activate it with the button G (4).
To exit the main menu, select the item "Exit" and
confirm with the button G (or just wait for 10 seconds).
5.1.1 Submenu "Picture"
Picture
–––––––––––––––––––––––––––––
Contrast
Brightness
Color
Tint
Save
To adjust Contrast, Brightness, Color and Tint,
select the corresponding function with the button G (4)
and then adjust the desired value with the arrow but-
tons: To increase the value, press the button
decrease the value, press the button
change will take effect immediately. A change of the tint
value will only be effective for NTSC signals.
To exit the submenu, select the menu item "Save"
and confirm with the button
5.1.2 Submenu "Features"
Features
–––––––––––––––––––––––––––––
OSD Mode
Sharpness
Motion
Motion Value
Save
Select the corresponding function with the button G;
then adjust the desired value with the arrow buttons
and
. Any change will take effect immediately.
OSD Mode will define the type of insertion of the
OSD menu: with a white background covering the pic-
ture (NOP or OR), with a transparent background
(AND) or with a negative picture section behind the
menu insertion (XOR).
With the function Sharpness activated (ON), the con-
tours of the video picture will be defined more clearly.
In case of fast movements in the video picture, the
function Motion allows to adjust a steady picture. With
the function activated (ON), the item Motion Value will
define the degree of the effect (the smaller the value,
the steadier the picture).
To exit the submenu, select the menu item "Save"
and confirm with the button
(3) or
40
20
40
50
(5); to
(3). Any
or
.
NOP
ON
ON
15
or
.
Publicité
Table des Matières
