versa CSG1300 Guide Rapide

Q u i c k S t a r t G u i d e
Cloud Services Gateway
CSG1300 | CSG1500|CSG3300|CSG3500
1. Cloud Services Gateway CSG1300 or CSG1500
2. Rack mounting kit—4 rack screws, 2 rear-post brackets, 2
rear-post bracket ears, 20 screws, and 2 ear-locking screws
3. 2 LTE antennas
Warning: This equipment is not suitable for use in
locations where children are likely to be present.
Avertissement: Cet équipement ne peut pas être utilisé
dans des endroits où des enfants sont susceptibles d'être
présents.
1
Rackmount the Device
2
1. Attach each of the rear-post brackets to the switch using six of
the included bracket screws.
2. Use the rack screws to secure the switch in the rack.
2
Adjust Rear-Post Bracket Ears
1. Lock the position of the rear-post bracket ears using the included
position-locking screws.
You can adjust the rear-post bracket ears to fit different rack
depths from 56 cm to 75 cm.
Package Contents
1
1
1
– 1 –
2 3
4. 2 Wi-Fi antennas
5. Power Cord
6. Console Cable—USB to RJ-45
3
Ground the Device
2
1
1. Ensure the rack is properly grounded and in compliance with
ETSI ETS 300 253. Verify that there is a good electrical
connection to the grounding point on the rack (no paint or
isolating surface treatment).
2. Attach the grounding wire (#18 AWG) to the grounding point
on the device rear panel. Then connect the other end of the wire
to rack ground.
Caution: The earth connection must not be removed unless
all supply connections have been disconnected.
Attention: Le raccordement à la terre ne doit pas être retiré
sauf si toutes les connexions d'alimentation ont été
débranchées.
4
Connect Power
1. Install two AC PSUs in the device.
2. Connect an external AC power source to each PSU.
3. Push the power button to power on the device.
4 5
1
2
E082020-CS-R01
15020000xxxxA
6