Assembly Instructions - Inferno SRPH84 Manuel D'utilisation

ASSEMBLY INSTRUCTIONS

Warning: This appliance requires installation
by a competent person. Proper assembly is
the responsibility of the installer.
Step1:
Align the edges of two meshes (5), put one mesh
support rod (4) on the overlap of two meshes (5), and tighten
them with four M5 x 10 screws.
Then attach the last mesh (5) and two mesh support rods (4)
to the assembled unit with eight M5 x 10 screws.
Hardware used
CC M5 x 10 screw
Step 2: Attach the reflector (2) to the emitter screen (3) with
three M6 x 12 bolt assemblies (AA).
Hardware used
AA M6 x 12 bolt assembly
Step 1
12
Step 2
3
7
4
CC
5
AA
3
2