Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Configuration And Operation
Menu Map
The menu map shows the organization of the configuration settings. Use it for reference
when configuring the Net-X™.
Main Function
<Net>
<Subnet>
<Universe #1> to
<Universe #8>
<DMX Output #1> to
<DMX Output #8>
<IP Address #1>
<IP Address #2>
<Device ID>
Using The Menu
The menu is used by pressing the 4 control buttons as described in the next sections.
Configuring Net Address
The Net is the address of the network on which the Net-X™ is operating. The Net address
must be configured if the Net-X™ is being used as an Art-Net™ hub.
To configure the Net setting, do the following:
1. Press <MENU> repeatedly until <Net> shows in the display.
2. Press <ENTER>. The number in the lower right-hand corner of the display flashes.
3. Press <UP> or <DOWN> until the desired Net shows.
4. Press <ENTER>.
Configuring Subnet Address
The Subnet is the address of the subnet of the network on which the Net-X™ is operating.
The Subnet address must be configured if the Net-X™ is being used as an Art-Net™ hub.
To configure the Subnet setting, do the following:
1. Press <MENU> repeatedly until <Subnet> shows in the display.
2. Press <ENTER>. The number in the lower right-hand corner of the display flashes.
3. Press <UP> or <DOWN> until the desired Subnet shows.
4. Press <ENTER>.
Page 14 of 62
Programming Levels
0–127
Sets the Net address
Sets the Subnet address
0–15
Sets the Art-Net™ universe for the corresponding
0–15
DMX Out port
(only necessary if the DMX port is set to Art-Net™)
ArtNet Input
Input source for each DMX Out port is Art-Net™
Input source for each DMX Out port is DMX In port 1
DMX #1 Input
DMX #2 Input
Input source for each DMX Out port is DMX In port 2
Without Input
DMX Out port is turned off
Sets the two IP addresses for the Net-X™
x.xxx.xxx.xxx
Note: The addresses cannot be the same.
Shows the Net-X™ device ID
xxxxxxxxx
Description
Net-X™ User Manual Rev. 2
Publicité
Table des Matières
