Installation Instructions - Ener-G+ HIW-750 Mode D'emploi

21. Use the heater only as described in this manual. Any other use not
recommended may cause fire, electric shock or injury.
Recommended heating power calculation:
You need 1.25 watts per cubic foot (0.03 cubic meters) of space to heat.
The heating capacity is 10 watts per square foot (0.09 m²) based on a ceiling
height of 8 feet (2.44 m). The recommended capacity is usually sufficient for
normal heating needs. The insulation quality of walls and windows are some of
the factors that influence heat losses that vary the power required to heat the
room. To heat a large room and increase your comfort, it is recommended to
install multiple heaters instead of one.
This heater requires a minimum mounting height of 8 feet (2.44 m) from the
ground. Keep it at least 12 inches (30 cm) from any vertical surface or walls.
SPECIFICATIONS
The heater has a thermal cut-off protection. If the thermal cut-off protection trips,
you must switch off the power. The unit should reset automatically after 10
minutes. If the thermal cut-off protection trips again, determine the reason for
overheating.
Model HIW-750
Volts 240 V AC
Watts 750 W
17.52"(44.5 cm) 17.52"(44.5 cm)
Height
18.7"(47.5 cm)
Width
5.12" (13 cm)
Depth

INSTALLATION INSTRUCTIONS

WARNING
• Installation must be performed in accordance with the requirements of CEC by
authorized personnel only.
Tools required (not included)
• Electric drill
• Phillips (cross-head) screwdriver
• Measuring tape
WARNING
• Turn off main power before beginning installation to avoid electric shock.
Do not install heater closer than 6" (153 mm) to any vertical or horizontal surface.
This minimum distance must be maintained. (Fig.1)
HIW-1000
240 V AC
1,000 W
22.64"(57.5 cm)
5.12" (13 cm)
HIW-1500 HIW-2000
240 V AC 240 V AC
1,500 W 2,000 W
17.52"(44.5 cm) 17.52" (44.5 cm)
28.54" (72.5 cm) 34.84" (88.5 cm)
5.12" (13 cm) 5.12" (13 cm)