Viking Range VIPR102SS Mode D'emploi page 6

VIKING RANGE, LLC
PREPARE THE DOWNDRAFT
Exterior Blower Installation
The downdraft is shipped without a blower. Purchase a Model
VEDV900 or VEDV1200 Exterior Blower and mount the 10"
discharge plate to the downdraft as follows:
1. Place the downdraft on its back on a table of fl at work surface.
2. Remove the 4 nuts and 2 clamp channels.
3. Remove 2 screws and the gear motor cover.
4. Carefully position the10" discharge plate under the bottom
fl ange of the downdraft.
5. Connect motor plug.
6. Replace the gear motor cover and 2 sheet metal screws.
7. Replace the 2 clamp channels and start the 4 nuts, do not
tighten.
8. Slide blower left of right to desired position. Use cover plate
(supplied) to close up any open space.
9. Tighten 4 nuts to secure top of blower. Use additional screws
(supplied) through bottom fl ange to secure bottom of dis-
charge plate.
NUTS
CLAMP
CHANNELS
SCREWS
GEARMOTOR
COVER
6
Downdraft Ventilators
10" ROUND
MOTOR
DISCHARGE
PLUG
PLATE
COVER
ADDITIONAL
SCREWS
BOTTOM
FLANGE
PLATE