Faults And How To Remedy; Warranty - MTD products ET350 Mode D'emploi

Replacing the cord spool
1
Be careful! Rotating cord
The trimmer is continuing to run!
z Before any work on the trimmer, discon-
nect the trimmer from the mains!
1. Press both locking tabs of spool cover simulta-
neously and remove
2. Remove cord spool
3. Clean, if necessary
4. Insert cord spool into housing

Faults and how to remedy

Problem Cause
• Spool is empty.
• The cutting cord is ripped out and
Tilt switch is not • The cutting cord has wrapped around
working.
• Line is torn and stuck inside spool.

Warranty

The warranty rules issued by our company or the im-
porter apply to every country. As part of the warranty,
we remedy malfunctions on your appliance free of
charge provided that this malfunction is caused by a
material or manufacturing defect. In the event of a
warranty claim, please turn to your dealer or the near-
est branch office.
G
R S
.
T
U
.
pulled back into the cord box.
the spool.
3
In order to prevent accidental unwinding,
do not remove the cord ends of the new
cord spool from the slits before inserting
V
the spool
5. Place the spool cover on the cord spool holder
so that the two locking tabs lock into place
1
Before switching on: Hold trimmer paral-
lel to the ground; otherwise, there is dan-
ger of injury.
Remedy
• Fit new spool.
• Remove the cord spool; if necessary,
pull lightly off the spool and put the
spool back on.
• Remove spool, check tightness of
winding and replace spool in the usual
way.
.
W
.
11