Tower Version - Schrack BX01P108007 Manuel D'utilisateur

I
NSTALLATION
T
OWER VERSION
This chapter describes the operations required to prepare the BATTERY BOX for use in the tower version.
WARNING: for your safety and that of your product, follow the information set out below exactly.
BEFORE CARRYING OUT THE FOLLOWING SEQUENCE OF OPERATIONS, ENSURE
THAT THE BATTERY BOX IS NOT CONNECTED TO THE ELECTRICITY MAINS, TO
THE UPS OR TO ANY OTHER BATTERY BOXES
Once removed from the packaging, the BATTERY BOX is ready for installation in tower configuration.
All that is needed to complete this configuration is to mount the two plastic covers provided in the upper part
of the BATTERY BOX, as described below:
The 2 covers have an interlocking system:
locate the cover mounting holes in the upper part of the
BATTERY BOX and very carefully engage them by exerting
gentle pressure (see figure at side).
Note: the covers are exactly the same so either can be mounted
indiscriminately in either part (front / back) of the top part of
the BATTERY BOX.
36