Tank (Waste Water Collecting Pipe); Air Pumps - Pontos AquaCycle 2500 Notice De Montage

5.3.3. Tank (waste water
collecting pipe)
Set up the tanks B2 and B3. Unevenness in the
floor can be compensated for with the frame
feet.
The distances between the tanks are defined by
the spacers being installed.
The waste water pipe is connected between the
stages by an intermediate piece.
EN 18
Assembly Manual AquaCycle 2500

5.3.4. Air pumps

Note!
The cable ties on the air pumps
V1 and V2 are for transport
protection only, and must be
removed.
The air pumps V1 and V2 are then only on the
positioning plate.
Route the hose of the air pump V1 (or V2) to
the tank of the preceding stage B1 (or B2).
It must be laid between the two frames. When
doing this, make sure that it is not squashed or
bent. It is connected by the thread on the
aerator flange. (The seal is in the accessories
pack)
Version 1.3