Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Step 2. Accessing the power cord connection
Terminal block
Access cover
Specified rating of power-supply-cord kit and circuit protection
Range rating, watts
120/240 volts 3-wire
8750-16500
This appliance must be supplied with the proper voltage at the proper frequency and must be connected to a dedicated, properly grounded
branch circuit protected by a 40 amp or larger circuit breaker.
NOTE
•
For power cord installations, go to Step 3 on page 4.
•
For conduit installations, go to Step 4 on page 5.
Step 3. Installing the power cord
Conduit connection
plate
Power cord
Installing a 3-wire power cord
Neutral terminal
Black
Live 1
Black White
Install_NE63A6711_DG68-01359B-01_EN+CFR.indb 4
Install_NE63A6711_DG68-01359B-01_EN+CFR.indb 4
Specified rating of power-
supply-cord kit and circuit
120/208 volts 3-wire
7801-12500
Ground strap
White
Red
Live 2
Red
Loosen and then remove the rear access cover screw
with a screwdriver. Remove the rear access cover by
pulling it right and then out. The terminal block will
then be accessible.
Diameter (inches) of range connection opening
protection, Amps
40 or 50 A
For power cord installations, hook the strain relief over the power cord
hole (1
⁄
") located below the rear of the drawer body. Insert the power
3
8
cord through the strain relief and tighten the device.
•
You must install the power cord with a strain relief.
•
Attach the strain relief to the 1
plate.
CAUTION
You must check voltage after connecting power cord.
Live 1 - Neutral
Live 2 - Neutral
Live 1 - Live 2
WARNING
The neutral or ground wire of the power cord must be connected to the neutral
terminal located in the center of the terminal block. The power leads must be
connected to the lower left and the lower right terminals of the terminal block.
1.
Remove the 3 lower terminal screws from the terminal block.
2. Insert the 3 terminal screws through each power cord terminal ring and into
the lower terminals of the terminal block. Be certain that the center wire
(white/neutral) is connected to the center lower position of the terminal
block.
3. Tighten screws securely to the terminal block. DO NOT remove the ground
strap connection.
4. Go to Step 5 on page 6 to continue with the installation.
4 - English
Power cord
Conduit
1
⁄
"
1
3
8
⁄
" opening in the conduit connection
3
8
120 V
120 V
208 V / 240 V
2021-05-18
2021-05-18
⁄
"
1
8
8:48:37
8:48:37
Publicité
Table des Matières
