Stopping The Engine - Pulsar PWP20 Mode D'emploi

Operating Instructions & Parts Manual
2 Inch & 3 Inch Water Pump

Stopping The Engine

To stop the engine in an emergency, simply turn the engine switch to the OFF position. Under normal conditions,
use the following procedure.
1) Move the throttle lever to the Slow position.
2) Turn the engine switch to the OFF position.
3) Turn the fuel valve lever to the Off position. When the
pump is not in use, leave the fuel valve lever in the OFF
position to prevent carburetor flooding and to reduce
the possibility of fuel leakage.
After use, remove the pump drain plug, and drain the pump chamber. Remove the filler cap, and flush the pump
chamber with clean, fresh water. Allow the water to drain from the pump chamber, then reinstall the filler cap and
drain plug.
Throttle Lever
Engine Switch
Fuel Valve Lever
OFF
13
Slow
OFF
ON