Safety Information - Rotho 20097 0022 Mode D'emploi

WARNING - DANGER OF DROWNING!
• This product is a bathing aid and does not provide additional safety
with regard to the risks associated with water!
• Children have drowned while bathing.
• Children can drown in as little as 2 cm (1 inch) of water in a very short time.
• Always remain in contact with your child during bathing.
• Never leave your baby unattended in the bath, even for a few moments.
If you need to leave the room, take the baby with you.
• Risk of scalding! Check the temperature of the water (maximum 37° C / 99°F).
Keep the child away from the water tap!
• Before bathing, make sure that the product is positioned correctly and safely!
• Do not use if the product is defective, if there is a part missing or borken - Risk of injury!
• Use only original replacement parts from Rotho Babydesign.
• The product may not be used or operated by persons (e.g. children) with restricted
physical, sensory or mental capabilities or a lack of knowledge!
• Make sure that the castors of the stand are locked.
Use the Spa Bath Stand only with the Baby Spa Whirlpool by Rotho Babydesign
(Part No. 20306 0001 01)
The SPA Whirlpool should only be used on the bath stand, until the child attempts
to walk on their own.
Maximum load for bathtub including water and child: 25 kg.

Safety information

Thoroughly read these user instructions prior to initial use.
• Above all, observe the safety information!
• The device must always be used as described in these user instructions.
• Keep these user instructions for information purposes.
• If you pass the product on to someone else, please include this copy of the
user instructions. The user instructions are a part of the product.
• Do not use the SPA Whirlpool on a raised surface that is not intended for this product.
• Make sure that the castors of the stand are locked.
• Keep the tub at a safe distance from heat sources!
• Do not use if the product is defective, or if a part is missing or loose – Risk of injury!
• Always ensure that the bathtub is firmly resting on the stand, and that the stand is
securely positioned on a level surface!
Assembly instructions
• Follow steps 1. to 11. in the assembly instructions for the stand.
• Glue the supplied stickers to the feet of the Spa bath tub stand
(see point 11 of the installation instcructions)
• The SPA stand can be individually adjusted in 3 stages. (92 cm-102 cm). See figure 9.
Cleaning
• Clean the product with a soft cloth and soapy water.
8
Subject to technical changes. Printing errors excepted.
> 2 cm
> 1 inch
max
25
kg
55
lbs