Velleman DB5 Notice D'emploi page 5

• Familiarise yourself with the functions of the device before actually using
it.
• All modifications of the device are forbidden for safety reasons. Damage
caused by user modifications to the device is not covered by the
warranty.
• Only use the device for its intended purpose. Using the device in an
unauthorised way will void the warranty.
• Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for
any ensuing defects or problems.
• Keep this manual for future reference.
4. Features
• 2 different sounds possible (ding - ding/dong)
• Built-in transformer
• kit contains
1x mechanical door chime + mounting accessories
o
1x doorbell push button
o
5. Mounting
Refer to the illustrations on pages 2 and 3 of this manual.
• Determine the location of the chime and push button and provide the
necessary wiring.
Notes:
• The electrical wiring should only be carried out by a qualified
person.
• Mount the chime and push button in a location protected from rain and
direct sunlight.
Push button
• Lift the transparent cover [A] (and name card) from the doorbell push
button [C].
• Release the small screw [B] and open the push button [C].
• Guide the electric wires through the hole in the back [D] and connect
them to the terminals [E].
• Close the push button [C] and tighten the screw [B].
• Put the name card and transparent cover [A] back in place.
Chime
• Gently lift the cover of the door chime.
• Use the chime as a template to mark the locations of the mounting holes
[F].
• Drill two holes in the marked locations and insert the included anchors.
• Before mounting the chime to the wall, complete the electrical wiring.
• Connect the doorbell push button to the terminals [G]. When connecting
the button between terminal 0 and 3, the chime will produce a two-tone
sound ('ding-dong') when pressing on the button; when connecting
03.03.2010
DB5
5
©Velleman nv