Table des Matières
Publicité
3-10. Installing And Threading Welding Wire
If necessary, move hub on support
for use of different size wire spool.
Install wire spool.
Adjust tension nut so wire is taut
when wire feed stops.
Lay gun cable out straight.
1
2
3
Open pressure assembly, hold wire
tightly, and cut off end. Push wire
through guides into gun.
Close and tighten pressure assem-
bly. Press JOG button until wire
comes out gun.
To adjust drive roll pressure, press
gun trigger to feed wire against
wood surface. Tighten knob so wire
does not slip.
Cut off wire. Close door.
Tighten
WOOD
Tools Needed:
15/16 in
Ref. ST-801 691 / S-0627-A
OM-180 058 Page 14
Publicité
Table des Matières
