Livestrong LS7.0B Manuel Du Propriétaire page 9

ASSEMBLY STEP 2
NOtE: tuck in wires as shown. Be sure that the pulse grip wires
will not be crushed when adjusting the seat back and forth.
HARDwARE bAG 2 CONtENtS :
Open HARDwARE bAG 2.
A
Attach the PULSE GRIP wIRES from
B
the rear of the exercise bike to the PULSE
GRIP wIRES from the PULSE GRIP
HANDLEbAR.
press the COVERED PULSE GRIP wIRES
C
into the PLASTIC CLIP as shown above. tuck
the ExPOSED wIRES into the RECESS
under the PULSE GRIP HANDLEbAR.
Attach the PULSE GRIP HANDLEbAR to the
d
SEAT SLIDE using 4 bOLTS (b).
BOLT (B)
10 mm
Qty: 4
9