Technaxx TX-101 Manuel D'utilisation page 17

Playback of Bluetooth enabled Smartphone's
Attention: Lift up the tone arm and put it on the rest!
1. Open the dust cover and turn the volume knob to on.
2. Press the USB/BT/REC button to toggle between USB and BT mode.
3. Open the Bluetooth on your Smartphone and search for the name
"Technaxx TX-101" to connect.
4. When successfully connected you hear a confirmation sound.
5. Select Next (15), Previous (17) or Play/Pause (16) key, to play your playlist.
Note: When you turn on the equipment and activate "Bluetooth mode" again,
the last connected Smartphone will be connected automatically!
AUX-IN Mode
Open the dust cover and turn the volume knob to on.
Connect the external audio device via 3.5mm cable (such as a CD player,
Smartphone, etc.) to the AUX-IN socket at the back of the equipment.
The audio signal from the external audio device will now be played
through the loudspeakers.
USB port and SD card slot
1. Open the dust cover and turn the volume knob to on.
2. Insert a USB device into the USB port, making sure it is fully inserted.
Alternatively, insert a SD card, making sure to insert it straight without bending.
IMPORTANT: Connecting the USB device upside down or backwards could
damage the audio system or storage media (USB drive, SD card). Check to
ensure the direction is correct before connection.
3. Set the function to USB mode. (If you have both a USB device and a
memory card inserted, remove one!) The system will start reading the storage
medium automatically after mode selection.
4. The system will then start audio playback from the media storage device
(USB or SD card) automatically.
5. The device supports for MP3 and WMA formats. During play status, press
PLAY/PAUSE button once to halt playing, press it again to continue.
7