Getting Started - Conrad LCR-816 Mode D'emploi

Getting started

Insert the supplied power cord into the power supply of the device and connect the plug to a
grounded power point.
Switch on the device with the power switch (POWER I/0).
The device shows a start screen and is ready for operation after a short initialisation phase.
Read the extensive operating instructions to make yourself familiar with the functions of the
product.
After use separate the connections and switch the product off.
Cleaning
Always observe the following safety instructions before cleaning the device:
If you open covers or remove parts – unless you can do this by hand – live parts
may be exposed.
Prior to cleaning or repairing the device, all lines must be detached and the
device must be turned off.
Do not use abrasive, chemical or aggressive cleaning agents such as benzene, alcohol etc.
These might attack the surface of the device. Furthermore, the fumes are hazardous to your
health and are explosive. Moreover, you should not use sharp-edged tools, screwdrivers or
metal brushes or such like for cleaning.
For cleaning the device or the display and the measuring cables, use a clean, slightly damp,
lint-free, antistatic cloth.
Disposal
Electrical and electronic products do not belong to the household waste.
Dispose of an unserviceable product in accordance with the relevant statutory
regulations.
You thereby fulfil your statutory obligations and contribute to the protection of the environment!
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
(www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited. This publication represent the technical status at the time of
printing.
© Copyright 2014 by Conrad Electronic SE. V1_0714_02-JH