Konwin KPT-5167L Manuel De L'utilisateur page 10

SELECTING THE DESIRED TEMPERATURE
UNIT AND
REMOTE
SETTING THE POWER OFF TIMER FUNCTION
NOTICE
UNIT REMOTE
1. Set the temperature by pressing the + or - button on the remote
control (NOT the control button on the product).
The LED d
The temperature can be set from 10°C to 49°C.
NOTE: Once the temperature has been set, the heater will remain
on until the room temperature increases to the set temperature. The
heater will cycle ON and OFF to maintain the set room temperature.
The Heater will operate in LOW HEAT mode and blow warm air
when the set temperature is 2°C higher than the room
temperature.
The heater will operate in HIGH HEAT mode and blow hot air when
the set temperature is 4°C higher than the room temperature.
When the room temperature reaches the set temperature the
heater will automatically go into FAN MODE and blow unheated air.
NOTE: The heater will cycle between FAN MODE and LOW HEAT
MODE as it maintains the set temperature.
The ower OFF timer function will allow for the heater to
power OFF after a certain set time and can only be set
while the heater is in the ON mode.
Turn the heater ON.
Press the timer button.
The LED display changes from the "temperature" to the "hours"
option for the timer. Hour options for the timer are 0 to 8 hours
(in 1 hour increments).
3. Continue to press the timer button to change the number of
hours the heater will run before powering itself OFF.
The LED display wil
seconds, and then revert back to the room temperature. The timer
indicator light will remain lit as long as the timer is set. The heater
will power OFF when the internal heater clock counts down the set
hour increments.
FUNCTION
FUNCTION
the selected hour increments for a few
10