Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The antenna must be installed outdoors. It can be temporarily or permanently fixed on the roof of a
house or a vehicle.
1. Choose the best location considering the following conditions:
•
Highest flat surface
•
For vehicle installation, do not exceed the vehicle size
Avoid any obstacle that could disturb the reception by keeping it as far away as possible from
metal masses, electrical appliances, etc ...
2. Fix the support / stand with 4 screws (not supplied) adapted to the fixing material (Fig.1). It is possible
to add a glue net suitable for the support (Fig.2)
3. Now assemble the rest of the elements using the tube for connecting the two supports. Tighten the 2
screws of the supports (3 Fig.4) so that all forms only one block.
1
NB: The coaxial cable can come out of the base of the antenna either by the central part (1 of Fig. 3) or by the
lateral outlet provided for this purpose (2 of Fig. 3).
In the second case, plan an additional hole (⌀ 8mm) for the passage of the coaxial cable. Remember to seal the
hole in the cable passage with silicone gasket.
4. Before connecting the antenna coaxial cable to your TV or TNT adapter, please be sure to check that
the +5 volt antenna option is disabled (refer to the operating manual of your TV or TNT adapter). An
antenna connection with this active function could cause irreversible damage to your equipment.
Installation
Warning: do not screw with an electric tool
Fig 1
2
Fig 3
Fig 2
English
Location for
collage
3
Fig 4
Publicité
Table des Matières
