Stid ARC1-XY Mode D'emploi page 2

ARC1 Mini Mullion reader
MA1 OEM Module
Installation instructions
For data signals, 10k pull-up resistors are connected internally to V
Available Baud rate
Factory Baud rate
Mode
Number of bits
Transfer mode
Stop bit
RS485
Bus architecture (RS485)
Wiring resistors R1 and R2 use extended features of the RS485 bus: FAIL-
SAFE (see RS485-AN-960).
R1 & R2: 1.5 kΩ resistor not supplied.
R : 120 Ω end-of-line resistor supplied
T
Smart mounting plate
General tolerance following ISO NFT 58-000 standard.
STid declares that the ARC1-XY reader is compliant to the essential requirements of the Directives RED 2014/53/EU, RoHS 2011/65/EU and Delegated directive.
A copy of our declaration is available on request from qualite@stid.com.
This device complies with part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such
modifications could void the user's authority to operate the equipment.
This device complies with the safety requirements for RF exposure in accordance with RSS-102 issue 5 for conditions of use and with §1.1307(b),
2.1091 and 2.1093 of the FCC rules Title 47 CFR Ch. I.
The maximum magnetic field level of the device is:
▪ 7.5 dBµA/m (at 10 meters) for 13.56 MHz frequency.
▪ 4 dBm for 2.4 GHz frequency.
STid reserves the right to make change without notice, for the purpose of product improvement.
Lecteur Etroit ARC1
Module OEM MA1
Notice d'installation
9600, 19200, 38400, 57600, 115200 bauds
ARC R & S: 9600; ARC W: 38400(SSCP
Default broadcast address 00h
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1110A10- Page 2 sur 6 - Ed. 06/04/2022
Lector Estrecho ARC1
Módulo OEM MA1
Procedimiento de instalación
conforme con
TTL pull-ups
(power supply voltage) for optimal wiring distances.
in
RS485 communication
), 9600(OSDP
®
Asynchronous
8
LSB first
1
Dimensions
ARC1/ARC1S
Declaration of compliance
NOM-024 -SCFI-2013
)
TM
More
reader
are available
protocol specification
Mounting
Pass the cables through the hole in the base.
-
Screw the base in its final location.
-
Connect the reader.
-
Test the readings and communication.
-
Place the reader on the base (clip the top part and then
-
pivot it down).
Lock the reader with the provided screw using the
-
specific tool.
US
FR
ES
details about
communication
in the
MA1/MA1S
(dimension in inch)