Table des Matières
Publicité
OPERATION
BEFORE TURNING KEY AND PULL STARTING ENGINE
CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK
SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY. WEAR SAFETY
GLASSES, HEARING PROTECTION, AND GLOVES DO NOT WEAR LOOSE FITTING
CLOTHES THAT COULD GET STUCK IN THE MACHINE MOVING PARTS, ONLY CHIP
WOOD, CHILDREN SHOULD NOT RUN THIS EQUIPMENT, STAY ALERT OF YOUR
SURROUNDING AND PERSONS THAT COULD APEAR IN THE CHIP PATH WHILE YOU
ARE WORKING.
UNIT IS DIRECT DRIVE, NO CLUTCH TO SLIP OR BURN UP.
Before starting make sure all chutes are clear of branches as the cutting wheel will turn
as you pull the recoil starter. Cutter wheel must be free to turn when starting.
PERFORMANCE OPERATION
Feed larger trees upto 3 inches in diameter slowly into the tubular feed chute allowing
the cutter wheel to regain speed. Shoving a tree into the cutter wheel will stall the
machine and damage the cutters or drive shaft.
WEAR GLOVES, AS THE CUTTER WILL GRAB THE BRANCHES AND PULL THEM
INTO THE MACHINE AND FROM YOUR HANDS.
Feed twigs, leaves, and branches up to 3/8 inch dia into the top hopper.
NEVER PLACE HANDS INTO THE TOP FEEDER.
To clear the top feeder turn the key off, remove it, unplug the spark plug.
Be safe, the cutters on this machine are high speed and very sharp.
SET BOTH OF YOUR WHEEL BRAKE PINS TO STABILIZE MACHINE DURING
OPERATION.
READ AND OBEY ALL WARNING LABELS ON THIS MACHINE.
12
Publicité
Table des Matières
