Assembly Instructions; Mounting-Base Unit To Bench; Mounting Motor/Head Assembly To Base Unit; Mounting Operating Handle - Oregon 511A Manuel D'instructions

0
6
A.
Mounting Base Unit to Bench/Wall:
1. Mount base assembly on a bench top or
post, using two (2) lag bolts or nuts and
bolts (not provided). Mount machine at
chest height for best visibility and ease of
operation.
2. For bench mounting, be sure the base unit
extends out from the bench edge clearing
the extending tabs of the base unit as
shown (see Figure 1).
Figure 1
Extending
Tabs
3. For wall application (see Figure 2) use
lag or expansion bolts (not provided).
Note: For wall mounting, the position
adjustment knob #4 (see Figure 4) will
need to be replaced with the supplied
nut and washer (#2 & #3).
Figure 2
B. Mounting Motor/Head Assembly to Base Unit
1. Mount pivot point on the motor/head
assembly into the pivot hole located
in the center of the base assembly back
(see Figure 3).
A S S E M B L Y I N S T R U C T I O N S
Figure 3
2. Insert bolt #1 into holder at base of
3. Attach washer #3 and knob #4 onto
Figure 4
C. Mounting Operating Handle
1. Attach operating handle #5 to motor/head
Figure 5
motor/head assembly into base
assembly back (see Figure 3).
bolt #1 on the back side of the base
assembly back (see Figure 4).
assembly using bolt #6a and nut #6b
(see Figure 5).