Introduction; Safety Rules And Precautions - Oregon 511A Manuel D'instructions

0
2
Keep this manual for future reference.
To ensure the correct use of the grinder and
to prevent accidents, do not start working
without having read this manual carefully.

SAFETY RULES AND PRECAUTIONS

The use of accessories or attachments not recommended by the
manufacturer may result in a risk of injury to the operators or bystanders!
1. Keep children away. All bystanders should be
kept at a safe distance from work areas.
2. Wear proper apparel. Never wear loose
clothing, neckties, bracelets, rings or any other
jewelry that could come into contact or get
caught in the grinding wheel or any other moving
parts. Non-slip footwear is recommended. Wear
protective hair covering to contain long hair.
3. Always use safety glasses or face
screen. Always wear gloves and protec-
tive eyewear while operating the grinder and while
profiling the wheel using the dressing stone.
Also use face or dust mask if cutting operation is
dusty. Everyday eyeglasses do not have impact
resistant lenses, they are not safety glasses.
4. Never stop the wheel with your hands. Never
attempt to stop the rotation of the grinding wheel
with your hands.
5. Disconnect tools before servicing. Make
sure the plug is disconnected when fitting or
changing the grinding wheel and during any
other maintenance operation or transport.
6. Keep guards in place and in good working
order. Never start the grinder without the wheel
guards in place.
7. Remove adjusting keys and wrenches.
Always make sure that keys and adjusting wrench-
es are removed before turning the grinder to the
"on" position.
I N T R O D U C T I O N
TO AVOID PERSONAL INJURY TO YOU AND TO BYSTANDERS,
READ AND FOLLOW THESE SAFETY RULES.
This manual explains how the various
components work and provides instructions
for carrying out the necessary checks and
maintenance operations.
8. Operate the grinder within its indicated
design specification. It will do the job better and
safer at the rate for which it was designed. Your
grinder has a plate indicating:
Size of arbor.
No-load speed in revolutions per minute.
Proper grinding wheel. Table 2, page 15.
Also, make sure that the voltage and
frequency indicated on the plate applied to
the grinder correspond to those of the
power outlet.
9. Reduce the risk of unintentional starting.
Always make sure that the start-up switch is in
the off position before connecting the plug to
the outlet.
10. Never use cables, plugs or extension cords
that are defective or non-standard.
11. Remove the plug from the outlet immediately
if the power cable/cord is damaged or cut. For
cable/cord repair or replacement, contact your
authorized dealer or service center. Note: The
power supply cable/cord comes complete with
terminals and circuit protection. Connecting the
power supply cable/cord terminals directly into the
switch completes the electrical system for the
grinder. The final electrical connection to the outlet
should be made in such a way as to prevent
damage by individuals or passing vehicles that
could endanger both them and the operator.