Error Code - Black & Decker BPWM09W Mode D'emploi

TROUBLESHOOTING & WARRANTY

ERROR CODE

E1
E2
E3
E4
E5
Page 32
POSSIBLE CAUSE
It takes over 30 minutes
to fill water but cannot
achieve its preset water
level.
The top lid is open.
The washer runs out of
balance for three times.
It takes over 10 minutes
to drain water and/or
cannot drain the washer
totally empty.
The water fills too much
to exceed its preset level.
SOLUTIONS
Check for washer not filling
properly and water leakage.
Close the lid.
Redistribute the load.
Ensure that the drain hose is not
kinked. Make sure that the drain
hose is no higher than 4 ft. above the
bottom of the washer and is no more
than 5 ft. away from the washer.
Call customer satisfaction center for
help.